51 47 000 Removing And Installing/Replacing Front (Inside) Left Or Right Entrance Cover Strip
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 135i, and 2010 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Risk of damage!
Risk of breakage to connecting lug on B-pillar trim panel.
IMPORTANT:
Risk of damage!
Do not raise entrance cover strip (1) over entire length simultaneously.
Detach entrance cover strip (1) at clips (2) from front to rear.
Detach entrance cover strip (1) from B-pillar trim panel at bottom in direction of arrow.
If necessary, lever out clips (2) from floor pan.
Installation:
Fit entrance cover strip (2) with preinstalled clips (1).
If necessary, replace faulty clips (1).
Connecting lug (3) of entrance cover strip (2) must not be damaged.