24 13 013 Replacing Output Flange Shaft Seal (GA6HP19)

Special tools required: 

• 00 0 020
• 24 2 351
• 24 2 352
• 24 2 353
• 24 2 370
• 24 2 380
• 24 2 410

Necessary preliminary tasks: 

• Remove underbody protection
• Remove heat shields
• Remove complete exhaust system. See EXHAUST SYSTEM, COMPLETE .
• Support transmission from underneath.
• Remove transmission crossmember. See REPLACING CROSSMEMBER FOR TRANSMISSION MOUNTING .

• Remove propeller shaft from transmission.
• Release center bearing.
• Tie propeller shaft to one side.

Tasks are described in removing propeller shaft. See REMOVING AND INSTALLING PROPELLER SHAFT (INSERTED) COMPLETELY .

Fig 1: Locating Propeller Shaft Bolts

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws.

Remove transmission bearing block (1).

Tightening torque 24 71 6AZ .

Fig 2: Identifying Convert Transmission Bearing Block Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Grip output flange (1) with special tool 23 0 020  .

Release nut with special tool 24 2 380  .

Tightening torque 24 13 2AZ .

Installation: 

Replace nut and secure with a mandrel (8 mm) by caulking.

Fig 3: Removing Flange

Courtesy of BMW OF NORTH AMERICA, INC.

Detach output flange from output shaft.

Remove spacer.

Attach special tool 24 2 353 to output shaft (1). See Fig 4.

Fig 4: Identifying Special Tool 24 2 353 On Output Shaft

Courtesy of BMW OF NORTH AMERICA, INC.

Screw in special tool 24 2 351 until it is firmly connected with shaft seal.

Pull out radial shaft seal by screwing in special tool 24 2 352.

Fig 5: Pulling Radial Shaft Seal

Courtesy of BMW OF NORTH AMERICA, INC.

Oil sealing lip of radial seal (1). Drive in radial seal (1) with special tool 24 2 370 and adapter ring 24 2 410 as far as it will go. See Fig 6.

Fig 6: Identifying Special Tools With Radial Seal

Courtesy of BMW OF NORTH AMERICA, INC.