27 10 050Replacing output flange for front axle output (ATC 400/500 X-Drive)
WARNING: This page is about a different car, the 2006 BMW X3, 2005 BMW X3, and 2004 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Do not move vehicle with engine power once propeller shaft has been removed. Replace output flange only in conjunction with a new radial shaft seal. After completion of work, check transmission OIL LEVEL . Use only approved GEAR OIL
. Failure to comply with this requirement will result in serious damage to the transfer case!
Procedure is identical to replacing RADIAL SHAFT SEAL FOR FRONT AXLE OUTPUT .