33 41 153 Replacing wheel bearing (outside diameter 75 mm) on rear axle shaft
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 128i, and 2009 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
- 33 4 031
- 33 4 041
- 33 4 042
- 33 4 043
- 33 4 047
- 33 4 048
- 33 4 049
Necessary preliminary tasks:
Press retaining ring (1) together using pliers and remove.
Installation:
Install retaining ring (1).
Check seating of retaining ring (1), correct if necessary.
Pull out wheel bearing with special tools 33 4 041 , 33 4 042 , 33 4 031 , 33 4 048 and 33 4 043 .
IMPORTANT:
Do not reuse old wheel bearing!
Installation:
Draw in new wheel bearing (1) with special tools 33 4 041 , 33 4 042 , 33 4 049 , 33 4 047 and 33 4 043 .
After installation:
- Adjusting parking brake .