16 11 071 Replacing rubber sleeve between fuel filler pipe and fuel tank
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2013 BMW 128i, 2012 BMW 128i, 2011 BMW 128i, 2010 BMW 128i, and 2009 BMW 128i. However, it is still accessible from the selected car via links, so may be relevant.
Recycling
Fuel escapes when fuel lines are detached. Have a suitable collecting container ready.
Catch and dispose of escaping fuel.
Observe country-specific waste-disposal regulations.
IMPORTANT:
Ensure adequate ventilation in the place of work!
Avoid skin contact (wear gloves)!
Before starting the engine for the first time:
Avoid skin contact (wear gloves)!
Before starting the engine for the first time:
- Fill fuel tank with at least 5 liters of fuel.
- Check ground connection at fuel filler neck to body for continuity. If necessary, clean contact surface between body and fuel filler pipe screw connection.
Necessary preliminary tasks:
IMPORTANT:
There may still be residual amounts of fuel in the tank.
Catch and dispose of escaping fuel.
If necessary, draw off residual amount of fuel via filler hose.
Catch and dispose of escaping fuel.
If necessary, draw off residual amount of fuel via filler hose.
Loosen hose clamps (1).
Detach rubber sleeve first from fuel filler pipe and then from fuel tank.
Installation:
Tightening torque 16 11 3AZ, see 16 11 FUEL TANK AND MOUNTING PARTS