18 00 020 Removing and installing complete exhaust system (N54)

WARNING: This page is about a different car, the 2010 BMW 535xi, 2009 BMW 535xi, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

31 2 220

WARNING: Scalding hazard!
These tasks should only be carried out on an exhaust system that has cooled down.

IMPORTANT: Removal of the exhaust system must be carried out with the assistance of a second person.

Support exhaust system with jack and special tool 31 2 220 and secure against falling out.

Fig 1: Supporting Exhaust System With Special Tool

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew nuts.

Installation:

Replace self-locking nuts.

Replace seal.

Tightening torque 18 00 1AZ

Fig 2: Locating Self-Locking Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

Release bolt and remove bracket (1).

Tightening torque 18 20 1AZ

Fig 3: Locating Bracket Bolt

Courtesy of BMW OF NORTH AMERICA, INC.

Release bolts along line and remove reinforcement plate (1).

Fig 4: Identifying Reinforcement Plate

Courtesy of BMW OF NORTH AMERICA, INC.

Unfasten nut.

Tightening torque, 18 00 4AZ

Fig 5: Locating Unfasten Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew nuts.

Tightening torque, 18 00 2AZ

Fig 6: Identifying Unscrew Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect pressure hose. Unscrew nuts.

Tightening torque, 18 00 6AZ

Fig 7: Locating Pressure Hose

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Check exhaust system for leaks.