Replacing Shaft Seal For Selector Shaft (GA6HP19Z)
Remove rear underbody protection.
Grip clamping sleeve (1) and slacken nut (2). See Fig 1 . Detach retainer (3) towards bottom using a screwdriver. Pull cable (4) out of holder. Upon installation, adjust selector lever. See ADJUSTING SELECTOR LEVER .
Release screw. Take off holder (1). See Fig 2 . Illustration shows E65. Upon installation, tighten screw to specification. See TORQUE SPECIFICATIONS .
Screw in Special Tool (24 5 361) until it is firmly connected with shaft seal. See Fig 3 .
Screw Special Tool (24 5 362) onto Special Tool (24 5 361) and tighten down. See Fig 4 . This pulls the shaft seal out of the transmission housing.
Oil sealing lip on shaft seal (1). Screw in shaft seal (1) with Special Tools (24 5 366) and (24 5 364) as far as it will go. See Fig 5 .