11 21 Crankshaft and Bearings
WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.
CRANKSHAFT AND BEARINGS - TIGHTENING TORQUE SPECIFICATION
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ Increment wheel on crankshaft | S54 | M5 10.9 | Replace screws | |
| Jointing torque | 5.0 Nm | |||
| Torque angle | 45 ° | |||
| Increment wheel on crankshaft | M5 10.9 | Replace screws | 13 Nm | |
| Increment wheel on crankshaft | M5 8.8 | Replace screws | 5.5 Nm |