67 61 005 Removing and installing/replacing drive unit with gearing for slide/tilt sunroof

WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with NOTES ON PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Necessary preliminary tasks:

Remove FRONT ROOFLINER TRIM .

NOTE: Secure drive unit with gearing for slide/tilt sunroof (2) against falling out.

Release screws (1)

Tightening torque: 3.5 Nm

Lower drive unit with gearing for slide/tilt sunroof (2).

NOTE: Screws (1) are microencapsulated.

Unlock plug connection (3), disconnect and remove drive unit with gearing for slide/tilt sunroof (2).

Fig 1: Identifying Slide/Tilt Sunroof, Plug And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Insert gear wheel (1) of drive with gear for actuating slide/tilt sunroof (2) in gear teeth.

Fig 2: Identifying Gear Wheel And Slide/Tilt Sunroof

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Initialize SLIDE/TILT SUNROOF .

Replacement:

Carry out PROGRAMMING/CODING .

IMPORTANT: There is a risk of permanent battery discharge if programming/coding is not carried out!