52 17 205 Removing and installing/replacing both rear panels on left or right front seat backrest (long version)

WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

Rear panel upper section:

Reach between rear panel and backrest cover and unclip rear panel upper section.
Remove rear panel towards top.

Installation:

Engage rear panel correctly in guide.

Retainers must not be damaged and must be preinstalled.

Fig 1: Removing Rear Panel Towards Top

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug connections (1) and disconnect.

Detach wiring harness retainers from rear panel.

Fig 2: Unlocking Plug Connections

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement only:

Release screws (1).

Remove monitor (2).

Unlock trim (3) with button and remove.

Fig 3: Unlocking Trim With Button

Courtesy of BMW OF NORTH AMERICA, INC.

Rear panel trim lower section:

Reach between rear panel and backrest cover and unclip rear panel lower section.

Installation:

Retainers must not be damaged and must be preinstalled.

Fig 4: Unclipping Rear Panel Lower Section

Courtesy of BMW OF NORTH AMERICA, INC.

Only when replacing on passenger side:

Unlock seat adjustment switch (1) and remove.

Fig 5: Identifying Seat Adjustment Switch

Courtesy of BMW OF NORTH AMERICA, INC.