51 21 330 Removing and installing/replacing window cavity cover strip on inner front door

WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove FRONT DOOR TRIM PANEL

Lever out cover (1) at rear slightly.

Start at rear with removal of window cavity cover strip (2).

Fig 1: Removing Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Pull off window cavity cover strip (1) towards top.

Replacement with Security version:

Cut window cavity cover strip (1) to length on B-pillar side to 680 mm.

Installation:

If necessary, replace faulty clips (3).

Insert window cavity cover strip (1) below cover (2).

Fig 2: Pulling Off Window Cavity Cover Strip

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Coat window cavity cover strip (1) with water before fitting.

Start with installation at front.

Fig 3: Identifying Window Cavity Cover Strip

Courtesy of BMW OF NORTH AMERICA, INC.