51 21 125 Removing and installing/replacing carrier for left or right outside door handle with lock cylinder

WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove cover on outside handle
Disconnect Bowden cable from door lock

Driver's side only:

Remove door lock on front door

NOTE: Version with Comfort Access/CA:
CA sensor (4) must not be damaged.

Unlock catches (2) on carrier (1).

Press lock cylinder (5) behind door outer skin (3).

Fig 1: Identifying CA Sensor, Catches, Carrier And Lock Cylinder

Courtesy of BMW OF NORTH AMERICA, INC.

If necessary, disconnect plug on CA module.

Pull carrier (3) towards rear/top until screw (1) of sheet metal slot (2) is free.

Remove carrier (3) for outside door handle.

Fig 2: Removing Carrier For Outside Door Handle

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Seals (1) on carrier (3) must not be damaged.

IMPORTANT: Water drainage channel (2) must not be fouled/clogged.

Fig 3: Identifying Water Drainage Channel, Seals And Carrier

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Remove Bowden cable for outside door handle on front door

Version with Comfort Access/CA:

Carry out PROGRAMMING/CODING