51 47 491 Removing and installing/replacing rear underbody protection
WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove FRONT UNDERBODY PROTECTION
Unfasten screws (1... 3).
Press heat shield (5) back.
Release screws (4) and remove underbody protection (6).
Installation:
Ensure correct seating.
Center underbody protection (6) and tighten down all screws.