24 00 043 Installing replacement transmission (GA6HP26Z/6HP32Z)
Drain automatic transmission fluid at oil drain plug.
Tightening torque: 24 11 6AZ . See AUTOMATIC TRANSMISSION - TIGHTENING TORQUES .
Recycling:
Catch and dispose of escaping transmission fluid.
Observe country-specific waste-disposal regulations
- Before installing replacement transmission, always flush transmission fluid cooler together with lines .
- After completion of work, check transmission oil level .
Replacement transmission is supplied filled with transmission fluid.
Use only the approved transmission fluid . See AUTOMATIC TRANSMISSION - OPERATING FLUIDS .
Failure to comply with this instruction will result in serious damage to the transmission.
Necessary preliminary tasks:
- Remove automatic transmission .
E65 only.
If necessary, remove transmission support block from transmission.
Mount transmission block on replacement transmission.
Release screws.
Remove transmission support block (1) and exhaust system bracket (2).
Tightening torque 24 71 6AZ . See AUTOMATIC TRANSMISSION - TIGHTENING TORQUES .
Convert transportation lock (1).
Convert all cable holders.
If necessary, modify cable holder.
Modify release lever for transmission interlock.
Convert all seal plugs.
Convert protective cap on output shaft.