11 37 040 Removing and installing/replacing right eccentric shaft sensor (N62/N62TU)

WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

(cylinder bank 1 to 4)

Necessary preliminary tasks:

Remove right cylinder head cover.

Unfasten screws.

Remove eccentric shaft sensor (1).

Fig 1: Locating Eccentric Shaft Sensor Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Read out fault memory of control unit of Digital Motor Electronics (DME).

Check stored fault messages.

Rectify faults.

Now clear the fault memory.