11 13 020 Removing and installing/replacing oil sump bottom section (N62/N62TU)

WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove reinforcement plate . See 31 10 010 REMOVING AND INSTALLING/REPLACING REINFORCEMENT PLATE .
Remove oil drain plug and drain engine oil.

Unlock plug connection (1) on oil level sensor and disconnect.

Release screws and remove oil sump bottom section (2).

Tightening torque, see 11 13 2AZ in OIL SUMP .

Installation:

Clean sealing surfaces.

Replace seal.

Replace screws.

Fig 1: Locating Oil Sump Bottom Section And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

When replacing oil sump bottom section:

Convert oil level sensor.

Replace sealing ring.