11 14 085 Removing and installing top right timing case cover (N62 / N62TU)

(cylinder bank 1 to 4) 

Necessary preliminary tasks: 

• Remove right cylinder head cover.  
• Remove vacuum pump  
• Remove both solenoid valves on right side  

Remove cable from holder.

Fig 1: Locating Cable

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1 and 2).

Tightening torque 11 14 3AZ. .

Remove timing case cover (3).

Fig 2: Identifying Timing Case Cover And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Free sealing face (2) on timing case cover (3) of seal debris and clean.

Fig 3: Identifying Timing Case Cover And Sealing Face

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Check adapter sleeves (1) for damage and correct installation position; replace if necessary.

Free sealing face (2) of seal debris and clean.

Fig 4: Identifying Adapter Sleeves And Sealing Face

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Replace gasket (1) and check for correct installation position.

Fig 5: Identifying Gasket

Courtesy of BMW OF NORTH AMERICA, INC.