51 71 482 Removing and installing/replacing left or right tension strut (on rear axle)
WARNING: This page is about a different car, the 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Observe SAFETY INSTRUCTIONS
for raising the vehicle
Do not drive vehicle without tension strut installed; failure to comply with this instruction will result in damage to the body!
Do not drive vehicle without tension strut installed; failure to comply with this instruction will result in damage to the body!
Release screws (1).
Remove tension strut (2).
Installation:
Tightening torque 51 61 3AZ .
Replace screws.