51 45 380 Removing and installing (replacing) right decorative strip on instrument panel

WARNING: This page is about a different car, the 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 317

Necessary preliminary tasks:

Remove SWITCH FOR HAZARD WARNING SYSTEM/CENTRAL LOCKING

If necessary, release screw (1).

Fig 1: Identifying Screw

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Risk of damage!
Do not turn special tool 00 9 317 when levering out and pay attention to pressure points.

Lever out decorative strip (2) at retaining points (1) starting from outside with special tool 00 9 317 .

If necessary, disconnect associated plug connection and remove decorative strip (2).

Fig 2: Removing Right Decorative Strip On Instrument Panel

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Clips (1) must be seated in associated mountings.

If necessary, remove clips (1) remaining on right decorative strip for instrument panel.

Replace damaged clips (1):

Turn clip (1) with screwdriver to left by approx. 60°.
Lever out clip (1) from below.

Fig 3: Removing Clips

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Remove RIGHT FRESH-AIR GRILLE
Remove CENTRE FRESH-AIR GRILLE