51 41 081 Replacing armrest on front left or right door trim panel (long version or from 03/2007)
WARNING: This page is about a different car, the 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove FRONT DOOR TRIM PANEL
Driver's side:
- Remove HANDLE RECESS
Passenger side:
- Remove TOGGLE SWITCH
- Remove DOOR HANDLE
IMPORTANT:
Only drill down to door trim panel area so as not to damage the contact surface.
Armrest is only welded to door trim panel during initial fitting; if necessary, release nuts in place of welding spots.
Drill out welding spots (1) on door trim panel (2) with 8 mm dia. welding spot drill bit.
Remove armrest.
Installation:
Secure armrest with nuts (3).