51 37 000 Removing and installing complete rear left or right power window unit

Necessary preliminary tasks: 

• Remove REAR DOOR WINDOW GLASS 

Slacken screws (1 and 2) (do not release).

Remove clamp (3) in direction of arrow.

Tightening torque 51 35 2AZ

Fig 1: Identifying Clamps And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Make sure guide (1) is correctly seated when fitting clamp (2).

Fig 2: Identifying Guide And Retaining Clip

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw on power window unit (2) through bore (1).

Disconnect plug connection (3) from drive (4).

Feed power window unit (2) in direction of arrow out of inner door panel.

Fig 3: Releasing Screw On Power Window Unit

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement: 

Release screws (1) and detach flat motor (2).

Tightening torque 51 35 1AZ .

Fig 4: Identifying Flat Motor And Screws

Courtesy of BMW OF NORTH AMERICA, INC.