51 22 090 Removing and installing/replacing door lock in left or right rear door

WARNING: This page is about a different car, the 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

51 2 190

Necessary preliminary tasks:

Remove SOUND INSULATION in rear area only
If necessary, remove CRASHPAD

Disconnect Bowden cable at bottom (1) and top (3) from door lock (2).

IMPORTANT: Bowden cable must be correctly located in mounts on door lock (2).

Seal (4) must be correctly positioned on Bowden cable.

NOTE: The operations for "Removing Bowden cable from door lock" end here.

Fig 1: Removing Bowden Cable And Door Lock

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug connection (1) at lugs (2) and detach from door lock (3).

Unclip locking rod (4) from door lock (3).

Fig 2: Identifying Plug Connection, Lugs And Door Locks

Courtesy of BMW OF NORTH AMERICA, INC.

Version with Soft Close Automatic:

Disconnect plug connection (1).

Unfasten cable tie (2).

Release screw (3) and nuts (4).

Tightening torque 51 22 10AZ .

Fig 3: Identifying Plug Connection, Cable Tie, Screw And Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Do not damage door lock seal during removal.

Release screws (1).

Remove door lock (2) from inside.

IMPORTANT: To avoid leaking and electrical malfunction:
Pull door lock (2) with special tool into corner (3), see Fig 6 and Fig 7.

Fig 4: Identifying Door Lock And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Seal (1) on door lock (2) must not be damaged.

Fig 5: Identifying Seal On Door Lock

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Install door lock and insert screws (1), do not tighten down.
Slide special tool 51 2 190 into opened rotary latch until latch engages in first stage.

Fig 6: Identifying Special Tool (51 2 190)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Pretension door lock (1) with knurled screw (2) until special tool 51 2 190 just contacts corner points (3).

IMPORTANT: To tension door lock (1), it is only permitted to turn knurled screw (2) by a further 1 to 1.5 turns (max.) (risk of damage).
Door lock seal must rest uniformly on inner door plate (water ingress).

Tighten down door lock screws, tightening torque 51 21 1AZ .

Fig 7: Identifying Door Lock, Knurled Screw With Special Tool (51 2 190)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Check function of child lock (1) on door lock (2).

Fig 8: Identifying Child Lock On Door Lock

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement with Soft Close Automatic:

Release nuts (1) and remove bracket (2).

Tightening torque 51 22 11AZ .

Fig 9: Identifying Bracket And Nuts

Courtesy of BMW OF NORTH AMERICA, INC.