51 21 300 Removing and installing or replacing window cavity cover strip on outside of left or right front door

WARNING: This page is about a different car, the 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 324

IMPORTANT: Observe procedure for using special tool 00 9 324 .

IMPORTANT: If reusing the existing window cavity cover strip (1), make sure it is not bent.

Lever out window cavity cover strip (1) with special tool 00 9 324 (starting at B-pillar).

Fig 1: Identifying Lever Out Window Cavity Cover Strip

Courtesy of BMW OF NORTH AMERICA, INC.

Pull window cavity cover strip (1) out of door mirror (2) in direction of arrow.

Installation:

Coat window cavity cover strip (1) with water before fitting.

Window cavity cover strip (1) must be flush at rear to door edge.

Fig 2: Pulling Window Cavity Cover Strip

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Seal (1) must be correctly fitted in cover strip (2).

Fig 3: Identifying Seal In Cover Strip

Courtesy of BMW OF NORTH AMERICA, INC.