51 12 810 Removing and installing / replacing deformation element on bumper carrier on left or right

WARNING: This page is about a different car, the 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove CARRIER FOR REAR BUMPER TRIM

Release screws (1).

Remove locator (2) straight towards rear.

Tightening torque 51 12 3AZ .

Fig 1: Identifying Locator And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Foam seal (1) on locator (2) must not be damaged.

Fig 2: Identifying Seal And Locator

Courtesy of BMW OF NORTH AMERICA, INC.