41 51 004 Front Left Or Front Right Door Adjustments

WARNING: This page is about a different car, the 2010 BMW 535xi, 2009 BMW 535xi, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

The BODY GAP DIMENSIONS serve as the basis for adjustment work.

Adjust screwed body parts from rear to front.

Make unpainted surfaces visible by also moving the hinges. Touch these up in the appropriate color.

NOTE: The following illustrations are schematic representations and are to be applied to the relevant vehicle type.

CAUTION: Do not damage adjoining body parts.

Minor corrections (realignment work) are permitted if the existing adjustment options are not sufficient.

Fig 1: Adjusting Screws On Door Hinges To At Top And Bottom

Courtesy of BMW OF NORTH AMERICA, INC.

Slacken screws (1) and (2) on door hinges to be adjusted at top and bottom.

Adjust door according to specified BODY GAP DIMENSIONS .

Check that adjoining body parts are flush in terms of height and correct if necessary.

After adjustment, tighten hinge screws and nuts.

Tightening torque 41 51 2AZ .

Tightening torque 41 51 3AZ

Fig 2: Identifying Adjoining Body

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: If necessary, adjust lock striker.

Slacken screws (1), adjust lock striker and tighten screws.

NOTE: Adjust lock striker approx. 90° in relation to door frame inside edge (2).

When the door is closed, the lock striker must not touch or scrape against the door lock. Look out for scratches.

Fig 3: Adjusting Lock Striker

Courtesy of BMW OF NORTH AMERICA, INC.

After installation note:

If the hinge is slackened on the body side, the area of the hinge must be sealed in a u-shape with sealant (1).

Fig 4: Identifying Hinge Sealant Applying Area

Courtesy of BMW OF NORTH AMERICA, INC.