4.1 Environment
WARNING: This page is about a different car, the 2009 MINI Cooper and 2008 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
ENVIRONMENT DESCRIPTION CHART
| Description: | Requirements: |
|---|---|
| All lifting platforms currently recommended by BMW (see ) for wheel alignment meet the requirements for the BMW KDS. | Wheel alignment pits |
| Pillar-type lifts with set-down device | |
| 2 plunger-type lifting platforms with set-down device | |
| Repair stands with set-down device | |
| No particular requirements have to be met in respect of the location at which the BMW KDS is used. The measuring device can be installed over working pits or on lifting platforms. | One measuring area (approx. 4.5 m x 7.0 m). |
| The rotating plates must be pinned to the platform |
The support surfaces for the rotating and sliding plates may only display the following maximum height difference:
- from left to right ± 0.5 mm
- from front to back ± 1.0 mm
- diagonally ± 1.0 mm.
NOTE:
A difference in the height of the rotary plates of ± 2 mm from left to right results in a measuring error of 4.8° in the camber.
As a comparison: The camber tolerance on the E36 is ± 10'. The tire tread difference or varying tire pressure cause measuring errors of the same magnitude.
As a comparison: The camber tolerance on the E36 is ± 10'. The tire tread difference or varying tire pressure cause measuring errors of the same magnitude.