11.3 Procedure (Bosch)
WARNING: This page is about a different car, the 2009 MINI Cooper and 2008 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.
- Go to the "Administration" screen
- Select the KDS button
- Select Bosch
- Label "Diskette 3.1", insert it into the drive on request and confirm with "OK" (2x) --> Setpoint data is copied to the diskettes.
- Insert setpoint data diskette 3.1 into the 3.1 floppy disk drive, insert operating system diskette 3.0 into the 3.0 drive.
- Switch on the machine in the usual manner.
IMPORTANT:
When creating the KDS diskettes, all data on the diskettes used is overwritten.
NOTE:
In the event of an error, a corresponding message is shown and the program is cancelled completely. The procedure must be run from the beginning again and all data on the diskette will be deleted. A new diskette may have to be used.