67 32 600 Replacing fan for front seat surface (comfort seat)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 535i, 2009 BMW 535xi, 2009 BMW 535i, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
US/CND front passenger seat (with OC3 mat) only:
Seat cover must not be separated from padding.
All parts must be replaced completely and released with the diagnosis system in event of defective fan, seat cover, seat heating, OC3 mat or padding.
Seat cover must not be separated from padding.
All parts must be replaced completely and released with the diagnosis system in event of defective fan, seat cover, seat heating, OC3 mat or padding.
Necessary preliminary tasks:
- Remove FRONT SEAT
- Partially remove COVER FOR FRONT SEAT
NOTE:
For purposes of clarity, illustration shows seat padding and seat cover removed.
Lift dividing net (1), pull fan for seat surface (2) out of seat padding (3) slightly and disconnect plug connection behind.
Remove fan for seat surface (2).