67 61 005 Removing and installing/replacing drive unit with gearing for slide/tilt sunroof

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 535i, 2009 BMW 535xi, 2009 BMW 535i, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) .

Necessary preliminary tasks:

Remove FRONT ROOFLINER TRIM

NOTE: Secure drive unit with gearing for slide/tilt sunroof (2) against falling out.

Release screws (1), tightening torque 54 13 1AZ .

Lower drive unit with gearing for slide/tilt sunroof (2).

NOTE: Screws (1) are microencapsulated.

Unlock plug connection (3), disconnect and remove drive unit with gearing for slide/tilt sunroof (2).

Fig 1: Identifying Slide/Tilt Sunroof, Screws And Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Insert gear wheel (1) of drive with gear for actuating slide/tilt sunroof (2) in gear teeth.

Fig 2: Identifying Gear Wheel And Slide/Tilt Sunroof

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Initialize SLIDE/TILT SUNROOF.

Replacement:

Carry out VEHICLE PROGRAMMING AND CODING

IMPORTANT: There is a risk of permanent battery discharge if programming/coding is not carried out!