64 53 702 Replacing line from evaporator to compressor (line on evaporator)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 535i, 2009 BMW 535xi, 2009 BMW 535i, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Risk of injury!
Refrigerant circuit is under high pressure!
Follow safety instructions for HANDLING R 134a REFRIGERANT .
Avoid contact with refrigerant and refrigerant oil.
Follow safety instructions for HANDLING REFRIGERANT OIL .

IMPORTANT: Risk of damage!
Restart engine only when A/C system has been correctly filled.
Follow INSTRUCTIONS for opening and replacing parts in refrigerant circuit.
If A/C system is opened for more than 24 hours:
REPLACE DESICCANT INSERT FOR A/C SYSTEM

Necessary preliminary tasks:

DRAWING OFF, EVACUATING AND FILLING THE A/C SYSTEM are not included in the time value given for this work operation
Remove FRESH AIR DUCT
Release expansion tank and place to one side
Remove vacuum tank and holder

Feed out rubber grommet (1).

Release nut (2) and detach refrigerant lines (3 and 4) in direction of arrow.

Installation:

Make sure rubber grommet (1) is correctly seated.

Replace sealing rings and moisten with refrigerant oil.

Tightening torque 64 53 7AZ .

Fig 1: Detaching Refrigerant Lines