51 43 255 Removing and installing/replacing trim for rear left or right roof pillar (front)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 535i, 2009 BMW 535xi, 2009 BMW 535i, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: FOLLOW safety instructions for working on cars with airbag systems.

IMPORTANT: Do not use any sharp-edged tools to remove trim (risk of damage to head airbag).

Necessary preliminary tasks:

Remove TRIM FOR REAR ROOF PILLAR (REAR) .

Detach expansion rivets (1) and clips (2) from trim (3).

Pull out trim (3) inwards/upwards.

Installation:

If necessary, replace faulty clips (2) or expansion rivets (1).

Fig 1: Identifying Expansion Rivets, Clips And Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Following parts of trim (2) must not be damaged or missing:

Insulating mat
Bores
Grommet
Retainer

Fig 2: Identifying Insulating Mat, Bores And Grommet

Courtesy of BMW OF NORTH AMERICA, INC.