51 21 125 Removing and installing/replacing carrier for left or right outside door handle with lock cylinder

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 535i, 2009 BMW 535xi, 2009 BMW 535i, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove COVER ON OUTSIDE HANDLE
Disconnect BOWDEN CABLE FROM DOOR LOCK

Driver's side only:

Remove DOOR LOCK on front door

NOTE:

Version with Comfort Access/CA:

CA sensor (4) must not be damaged.

Unlock catches (2) on carrier (1).

Press lock cylinder (5) behind door outer skin (3).

Fig 1: Identifying Catches On Carrier And Lock Cylinder

G04760967

Courtesy of BMW OF NORTH AMERICA, INC.

If necessary, disconnect plug on CA module.

Pull carrier (3) towards rear/top until screw (1) of sheet metal slot (2) is free.

Remove carrier (3) for outside door handle.

Fig 2: Identifying Carrier For Outside Door Handle

G04760968

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Seals (1) on carrier (3) must not be damaged.

IMPORTANT: Water drainage channel (2) must not be fouled/clogged.

Fig 3: Identifying Seals On Carrier

G04760969

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Remove BOWDEN CABLE FOR OUTSIDE DOOR HANDLE ON FRONT DOOR

Version with Comfort Access/CA:

Carry out PROGRAMMING/CODING