36 10 713 Checking one road wheel on balancing machine for face and radial runout (wheel removed)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 535i, 2009 BMW 535xi, 2009 BMW 535i, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

Necessary preliminary tasks:

REMOVE WHEEL .

Mount wheel in balancing machine.

To avoid retooling errors, fit the wheel on the balancing machine in the same way as it is also fitted on the car (valve position facing down).

Fig 1: Mounting Wheel In Balancing Machine

Courtesy of BMW OF NORTH AMERICA, INC.

Use suitable wheel centering element supplied with corresponding balancing machine.

Basic flange
Wheel centering element
Type flange
Clamping nut

Also refer to information on WORKSHOP EQUIPMENT .

Fig 2: Identifying Wheel Centering Elements

Courtesy of BMW OF NORTH AMERICA, INC.

Use special tool 36 1 030 for testing.

Special tool 36 1 030 consists of:

Stand 36 1 031
Post with clamp 36 1 032
Holder with clamp 36 1 033
Clamp 36 1 034
Measuring roller 36 1 035
Dial gauge 36 1 036

Fig 3: Identifying Special Tool 36 1 030
Courtesy of BMW OF NORTH AMERICA, INC.

Position special tool 36 1 030 on tire tread.

Turn wheel by hand and measure max. RADIAL TIRE RUNOUT .

NOTE: Measuring device must be vertical to tire tread.

Fig 4: Measuring Max. Radial Tire Runout

Courtesy of BMW OF NORTH AMERICA, INC.

Position special tool 36 1 030 on tire side wall.

Turn wheel by hand and measure max. LATERAL TIRE RUNOUT .

NOTE: Measuring device must be vertical to tire side wall.
Never measure on printed text on tire!
If necessary, CHECK DISK WHEEL (RIM) FOR RADIAL AND FACE RUNOUT .

Fig 5: Measuring Max. Lateral Tire Runout

Courtesy of BMW OF NORTH AMERICA, INC.