52 17 205 Removing and installing/replacing both rear panels on left or right front seat backrest (long version)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 535i, 2009 BMW 535xi, 2009 BMW 535i, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.

Rear panel upper section:

Reach between rear panel and backrest cover and unclip rear panel upper section.
Remove rear panel towards top.

Installation:

Engage rear panel correctly in guide.

Retainers must not be damaged and must be preinstalled.

Fig 1: Removing Rear Panel Upper Section

G05504327

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock plug connections (1) and disconnect.

Detach wiring harness retainers from rear panel.

Fig 2: Identifying Plug Connections

G05504328

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement only:

Release screws (1).

Remove monitor (2).

Unlock trim (3) with button and remove.

Fig 3: Identifying Trim, Monitor And Screws

G05504329

Courtesy of BMW OF NORTH AMERICA, INC.

Rear panel trim lower section:

Reach between rear panel and backrest cover and unclip rear panel lower section.

Installation:

Retainers must not be damaged and must be preinstalled.

Fig 4: Identifying Rear Panel Trim Lower Section

G05504330

Courtesy of BMW OF NORTH AMERICA, INC.

Only when replacing on passenger side:

Unlock seat adjustment switch (1) and remove.

Fig 5: Identifying Seat Adjustment Switch

G05504331

Courtesy of BMW OF NORTH AMERICA, INC.