52 17 205 Removing and installing/replacing both rear panels on left or right front seat backrest (comfort)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 535i, 2009 BMW 535xi, 2009 BMW 535i, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.

Operation is shown on the left seat. When removing from the right seat, transpose the pull and striking sides accordingly.

Rear panel upper section:

Grip between rear panel and backrest cover on door side until clip can be felt (do not pull).
At same time, firmly punch towards middle of seat on inner side (tunnel side) at top.
Upper retainers spring out of seat guide.
Pull upper rear panel up out of lower guides.

Fig 1: Pulling Upper Rear Panel Of Lower Guides
Courtesy of BMW OF NORTH AMERICA, INC.

NOTE:

Retainer
Guide
Upper rear panel

Fig 2: Identifying Retainer, Guide And Upper Rear Panel
Courtesy of BMW OF NORTH AMERICA, INC.

Rear panel trim lower section:

Grip between rear panel and backrest cover on door side until clip can be felt (do not pull).
At same time, firmly punch towards middle of seat on inner side (tunnel side) at top.
Upper retainers spring out of seat guide.
Pull lower rear panel up out of lower guides

Fig 3: Pulling Lower Rear Panel Of Lower Guides
Courtesy of BMW OF NORTH AMERICA, INC.

Unclip springs (1) on left and right.

Remove lower rear panel (3) upwards out of guide (2).

Fig 4: Identifying Lower Rear Panel Of Guide

Courtesy of BMW OF NORTH AMERICA, INC.