25 11 001 Replacing complete shift lever

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 535i, 2009 BMW 535xi, 2009 BMW 535i, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove SELECTOR LEVER
Remove VIBRATION DAMPER (if fitted).

Detach mount from selector lever.

Installation:

Grease ball joint.

Fig 1: Identifying Selector Lever

G04748964

Courtesy of BMW OF NORTH AMERICA, INC.

Detach rubber gaiter from selector lever.

Fig 2: Identifying Rubber Gaiter

G05502534

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Degrease selector lever (1).

Coat rubber bellows on inside of shaped section (2) with Circolight.

Pull rubber gaiter from above over selector lever and align.

Arrow (3) on rubber gaiter must point in direction of travel (A).

Fig 3: Identifying Selector Lever And Shaped Section

G04755743

Courtesy of BMW OF NORTH AMERICA, INC.