LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2010 >> Cooper S, 2D Hatchback, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1903 (Automatic Transmission - Repair) >> Transmission Case, Oil Sump >> 24 11 011 Removing and installing/sealing or replacing transmission sump (GA6HP19Z)

24 11 011 Removing and installing/sealing or replacing transmission sump (GA6HP19Z)

WARNING: This page is about a different car, the 2010 BMW 535i, 2009 BMW 535i, and 2008 BMW 535i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Remove transmission sump only after it has cooled down.
After completion of work, check TRANSMISSION FLUID LEVEL .
Use only the approved TRANSMISSION FLUID .
Failure to comply with this requirement will result in serious damage to the automatic transmission!

Recycling: 

Catch and dispose of escaping transmission fluid.

Observe country-specific waste-disposal regulations.

Necessary preliminary tasks: 

Remove rear underbody protection.

Remove exhaust system bracket from transmission.

Remove oil drain plug (1).

Tightening torque: 24 11 6AZ .

Drain automatic transmission fluid.

Installation: 

Replace oil drain plug.

Fig 1: Identifying Oil Drain Plug
G04726107Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew all bolts.

Remove transmission sump (1).

IMPORTANT: Transmission with plastic oil sump
From 11/04 new M6 x 28.5 T40 Torx bolt can be retrospectively replaced.

Installation: 

Insert screws (2) until screw heads make contact.

Insert all further screws in diagonal sequence from inside to outside until screw heads make contact.

Tightening torque: 24 11 5AZ .

Fig 2: Identifying Transmission Sump
G04726108Courtesy of BMW OF NORTH AMERICA, INC.

Remove gasket (1) from transmission sump.

Clean transmission oil sump to remove residual oil

Clean sealing faces and groove with a cloth.

Insert new gasket in transmission sump groove.

IMPORTANT: Do not degrease transmission sump with cleaning agent.
Fig 3: Identifying Transmission Sump Gasket
G04726109Courtesy of BMW OF NORTH AMERICA, INC.

Replace sealing ring (1) on oil filter tube.

Fig 4: Identifying Sealing Ring On Oil Filter Tube
G04726110Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

The gasket is correctly installed when it is engaged in the locating opening of the transmission sump.

Fig 5: Locating Gasket Sump Screw
G04726111Courtesy of BMW OF NORTH AMERICA, INC.