Dynamic Stability Control DSC 8: Operation
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 535i, 2009 BMW 535xi, 2009 BMW 535i, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.
The DSC button is in the center console switch cluster (SZM)
The DSC button has 2 functions that can be set by pressing the button for different lengths of time.
FUNCTION CHART
| Press button | Function | Remarks |
|---|---|---|
| short < 3 seconds | DTC function activated. | DTC indicator light on. DSC indicator and warning light on. |
| long > 3 seconds | DSC is completely deactivated | DSC indicator and warning light on. This mode is intended for service work (e.g. brake dynamometer). |
NOTE:
Reactivating DSC
Briefly pressing the button again reactivates the DSC function. The DSC indicator and warning light goes out (unless the system has developed a fault).
If the DSC button remains pressed for longer than 10 seconds (e.g. by a handbag on the center console), DSC will detect an operating error. The DSC function remains active and cannot be deactivated until the ignition has been switched off and on again.
Briefly pressing the button again reactivates the DSC function. The DSC indicator and warning light goes out (unless the system has developed a fault).
If the DSC button remains pressed for longer than 10 seconds (e.g. by a handbag on the center console), DSC will detect an operating error. The DSC function remains active and cannot be deactivated until the ignition has been switched off and on again.