72 11 302 Removing and installing/replacing all seat belts (comfort)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove trim for parcel shelf . See 51 46 006 REMOVING AND INSTALLING/REPLACING TRIM FOR REAR PARCEL SHELF .
Remove rear seat . See SEATS - REPAIR INSTRUCTIONS .

WARNING: Read and comply with safety regulations for handling airbag modules and pyrotechnical belt tensioners.
Incorrect handling may trigger the pyrotechnical seatbelt tensioner or side airbag and thereby cause injuries.

Switch off ignition!

Removing left and right seat belts:

Release screw (1) from automatic reel (2) on left and right.

Tightening torques 72 11 20AZ . See 11 SEAT BELTS .

Remove automatic reels (2) on left and right.

Unscrew bolt (3).

Tightening torque 72 11 20AZ . See 11 SEAT BELTS .

Remove automatic reel (4).

Installation:

Guide lug of automatic reels (2 & 4) must be seated in body opening.

Fig 1: Identifying Automatic Reels, Bolt And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (2) on left and right.

Tightening torque 72 11 22AZ . See 11 SEAT BELTS .

Remove left and right seat belts (1).

Installation:

Secure fittings of seat belts (1) on left and right through stop (3) in guide.

Fig 2: Identifying Seat Belts, Guides And Stop

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Tightening torque 72 11 23AZ . See 11 SEAT BELTS .

Remove lower strap (2) on left and right.

Remove lower strap (3).

Installation:

Holder for lower strap (3) must be fitted below lower strap on right (2).

Fig 3: Identifying Lower Strap And Screw

Courtesy of BMW OF NORTH AMERICA, INC.