64 11 323 Replace the button caps of the heater controls (up to 02/2007)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 341

Tape button caps off with adhesive tape (1).

Fig 1: Taping Button Caps Off With Adhesive Tape

Lever button caps (1) off with special tool 00 9 341.

Fig 2: Levering Button Caps Off

Remove adhesive tape. Pull light elements (1) out of the intake of the operating unit with a suitable tool.

Fig 3: Pulling Light Elements Out Of Intake Of Operating Unit

Detach the button caps (1) from the die cast tree (2). Carefully deburr the button caps, if applicable.

Fig 4: Detaching Button Caps From Die Cast Tree

Clip light elements (1) into the button caps (2) as shown. Clip button caps into the operating unit. Installation note: The button cap for air recirculation function has two light elements.

Fig 5: Clipping Light Elements Into Button Caps

Check function of the air conditioning.