51 2.... Removing window cavity cover strip with special tool 00 9 324 at front or rear

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 318 . See MAINTENANCE AND GENERAL INFORMATION - SPECIAL TOOLS .
00 9 324

Open complete door window glass.

Front door:

Insert special tool 00 9 324 at front (at A-pillar) in window cavity (1) (letters TOP pointing upwards).

Rear door:

Insert special tool 00 9 324 at rear (at C-pillar) in window cavity (2) (letters TOP pointing upwards).

Fig 1: Inspecting Special Tool At Rear (At C-Pillar) In Window Cavity

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: For purposes of clarity, picture shows inner door panel and door window glass removed.

Special tool 00 9 324 must be correctly guided under window cavity cover strip (1).

2 Short leg, bottom
3 Long leg, top (TOP)

Fig 2: Identifying Window Cavity Cover Strip
Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Start at the front or rear, depending on the model.

IMPORTANT: Risk of damage!
Raise window cavity cover strip (3) no more than 5 mm in each levering operation, otherwise the strip will be bent.

Fig 3: Identifying Cavity Cover Strip

Courtesy of BMW OF NORTH AMERICA, INC.

Position special tool 00 9 318 on door trim panel (1).

Slide screwdriver (2) into special tool 00 9 324 and lever window cavity cover strip (3) upwards no more than 5 mm.

Guide special tools 00 9 324 and 00 9 318 towards front/rear and lever out window cavity cover strip (3) in the process.