35 11 000 Removing and installing complete bearing block for foot pedal
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove pedal trim . See REMOVING AND INSTALLING/REPLACING PANEL FOR PEDALS .
- Vehicles with electric steering column: remove electric steering column drive . See 67 64 010 REMOVING AND INSTALLING/REPLACING DRIVE UNIT FOR ELECTRIC STEERING COLUMN ADJUSTMENT .
- Vehicles with manual transmission: Remove clutch pedal and CLUTCH MASTER CYLINDER .
IMPORTANT:
After completion of work, carry out function check.
Unfasten plug connection (1). Remove locking clip (2) and disengage and pull out locking pin. Release nuts (3) and remove bearing block. Installation: Replace self-locking nuts. Tightening torque 35 11 1AZ. .