33 41 151 Replacing left or right wheel bearing on rear axle shaft

WARNING: This page is about a different car, the 2010 BMW 528i, 2009 BMW 528i, and 2008 BMW 528i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove drive flange for rear axle shaft
Detach wheel bearing inner race from drive flange

If necessary, raise wheel carrier slightly with workshop jack.

Release screws with 3/8 Torx socket.

Tightening torque 33 41 2AZ . See 41 WHEEL BEARINGS .

Remove wheel bearing.

Fig 1: Locating Wheel Carrier Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Keep contact surface (2) of wheel bearing/wheel carrier clean and free from oil and grease.

Except when replacing: Recondition tapped holes (1). Install new wheel bearing.

Fig 2: Identifying Tapped Holes

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

Adjust handbrake . See 34 10 014 ADJUSTING HANDBRAKE .