12 61 280 Removing and installing/replacing oil pressure sensor (N52, N52K, N51, N54, N53)
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Switch off ignition
- N52, N52K, N51, N53 only:
- Remove IGNITION COIL COVER
- N54 only:
- Remove intake filter housing
WARNING:
Scalding hazard!
Only perform this task on an engine that has cooled down.
Only perform this task on an engine that has cooled down.
Installation location:
Oil filter housing, front left.
Engine oil may emerge when oil pressure sensor is replaced have a cleaning cloth ready.
Unlock plug (1) and remove. Release oil pressure sensor (2). Tightening torque 12 61 1AZ .
Installation:
Check engine oil level, top up engine oil if necessary.