11 41 Oil Pump with Strainer and Drive
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.
TIGHTENING TORQUE SPECIFICATIONS - OIL PUMP WITH STRAINER AND DRIVE
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| Optional extra designation: SA203 = All-wheel drive | ||||
| 1AZ ASA screws (2 x with optional extra SA203) (3 x without optional extra SA203) Suction pipe to bedplate. The end faces of the aluminium screw heads are painted blue. |
N52K | M6 x 30 | Replace screws. Thread repairs exclusively with aluminium Helicoil threaded insert. Jointing torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 4 Nm | |||
| Torque angle | 100° | |||
| 2AZ ASA screw (1x) Oil pump to bedplate. The end faces of the aluminium screw heads are painted blue. |
N52K | M8 x 123 | Replace screw. Thread repairs exclusively with aluminium Helicoil threaded insert. Jointing torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 10 Nm | |||
| Torque angle | 180° | |||
| 3AZ ASA screws (2x) Oil pump to bedplate. The end faces of the aluminium screw heads are painted blue. |
N52K | M8 x 31 | Replace screws. Thread repairs exclusively with aluminium Helicoil threaded insert. Jointing torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 10 Nm | |||
| Torque angle | 90° | |||
| 4AZ ASA screw (1x) Chain module to crankcase. The end faces of the aluminium screw heads are painted blue. |
N52K | M6 x 16 | Replace screw. Thread repairs are not permitted! Jointing torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 4 Nm | |||
| Torque angle | 45° | |||
| 5AZ ASA screws (2x) Chain module to oil pump. The end faces of the aluminium screw heads are painted blue. |
N52K | M6 x 16 | Replace screws. Thread repairs exclusively with aluminium Helicoil threaded insert. Jointing torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 4 Nm | |||
| Torque angle | 45° | |||
| 6AZ Fillister head bolt (1x) Sprocket wheel to oil pump. |
N52K | M8 x 20 | Jointing torque and angle of rotation must be observed without fail. | |
| Jointing torque | 20 Nm | |||
| Torque angle | 45° |