11 21 Crankshaft and Bearings
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.
TIGHTENING TORQUE SPECIFICATIONS - CRANKSHAFT AND BEARINGS
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ Increment wheel on crankshaft | S54 | M5 10.9 | Replace screws | |
| Jointing torque | 5.0 Nm | |||
| Torque angle | 45° | |||
| Increment wheel on crankshaft | M5 10.9 | Replace screws | 13 Nm | |
| Increment wheel on crankshaft | M5 8.8 | Replace screws | 5.5 Nm |
TIGHTENING TORQUE SPECIFICATIONS - CRANKSHAFT AND BEARINGS
| Type | Thread | Tightening specification | Measure | |
|---|---|---|---|---|
| 1AZ Hexagon screw (central screw) (1x) Hub of vibration damper to crankshaft. |
N52K | M16 x 80 | Replace screw. Screw and thread are lightly oiled. Jointing torque and angle of rotation must be observed without fail. |
|
| Jointing torque | 100 Nm | |||
| Torque angle | 360° |