21 52 500 Removing And Installing/Replacing Clutch Master Cylinder

Necessary preliminary tasks: 

• Remove TRIM PANEL for pedal assembly.
• Remove MICROFILTER HOUSING on left.
• Remove LIGHT MODULE .

Draw off brake fluid up to supply hose of clutch hydraulic system (1). For this purpose, use only a vacuum pipe that is exclusively used for removing brake fluid.

Detach supply hose (1) from expansion tank.

Fig 1: Identifying Hose

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect spring (1).

Fig 2: Identifying Spring

Courtesy of BMW OF NORTH AMERICA, INC.

Remove retainer (1) using screwdriver and press out pin.

Fig 3: Identifying Retainer And Pin

Courtesy of BMW OF NORTH AMERICA, INC.

Detach retainer (1) with a screwdriver (2).

Detach hydraulic line from clutch master cylinder.

Fig 4: Identifying Retainer

Courtesy of BMW OF NORTH AMERICA, INC.

Remove lock (1) from pin with aid of screwdriver (2).

Lever out pin (3) with aid of screwdriver.

Remove clutch master cylinder.

Installation: 

Replace pin.

Press in pin until lock (1) can be seen to snap into place.

Fig 5: Identifying Lock And Pin

Courtesy of BMW OF NORTH AMERICA, INC.

Detach supply hose (1) from clutch master cylinder.

Fig 6: Identifying Hose

Courtesy of BMW OF NORTH AMERICA, INC.

Lever out shift element (1) from clutch master cylinder (2) with screwdriver.

Release plug connection (3) and disconnect plug (4) from shift element (1).

Fig 7: Identifying Shift Element, Clutch Master Cylinder And Plug

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Shift element is secured against incorrect installation.

Shift element must snap audibly into place.

Fig 8: Identifying Shift Element

Courtesy of BMW OF NORTH AMERICA, INC.