12 61 280 Removing and installing/replacing oil pressure sensor (N14)

WARNING: This page is about a different car, the 2007 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

11 7 020

WARNING: Scalding hazard!

Only perform this task on an engine that has cooled down.

Necessary preliminary tasks:

Switch off ignition

Installation location:

On cylinder head, left.

Engine oil may emerge when oil pressure sensor is replaced; have a cleaning cloth ready.

Release clamps (2).

Detach air intake hose (3).

Remove clean air pipe (4).

Fig 1: Pressure Pipe, Air Pipe, Retaining Nut And Clamps

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock and detach plugs (1 and 3).

Unlock and disconnect line (2).

Carefully pull cable duct (4) upwards slightly.

Fig 2: Cable Duct, Plugs, Line And Removal Direction

Courtesy of BMW OF NORTH AMERICA, INC.

Release oil pressure sensor (1) with special tool 11 7 020.

Installation:

Replace sealing ring.
For tightening torque refer to 12 61 1AZ in 12 61 DISPLAY: OIL PRESSURE, OIL TEMPERATURE, OIL LEVEL .
Check engine oil level, top up engine oil if necessary.

Fig 3: Special Tool (11 7 020) And Oil Pressure Sensor
Courtesy of BMW OF NORTH AMERICA, INC.