12 14 537 Replacing pulse generator on inlet camshaft (N14)

WARNING: This page is about a different car, the 2007 MINI Cooper. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Switch off ignition
Read out fault memory of DME control unit
Check stored fault messages

Unlock plug (1) and remove.

Release screw and remove pulse generator (2).

Installation:

Replace sealing ring and coat with antiseize agent.

For tightening torque refer to 13 62 4AZ in 13 62 SENDERS FOR CONTROL UNIT .

Fig 1: Plug, Mounting Screw And Pulse Generator

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Now clear the fault memory.