11 14 005 Replacing front crankshaft radial seal (N14)

Special tools required: 

• 11 9 601 
• 11 9 602 
• 11 9 603 

Necessary preliminary tasks: 

• Remove A/C line from compressor.
• Remove vibration damper.

If the central bolt is released, the sprocket wheels of the timing chain and the oil pump will no longer be non-positively connected to the crankshaft. The camshafts can warp in relation to the crankshaft (risk of damage!)  .

Fig 1: Central Bolt Damage Warning

Courtesy of BMW OF NORTH AMERICA, INC.

Drive PTFE ring inwards with a drift (1) until PTFE ring tilts outwards at bottom.

Fig 2: Locating Drift

Courtesy of BMW OF NORTH AMERICA, INC.

Secure special tool 11 9 601  with screws (1) to crankshaft to 15 Nm.

Fig 3: Crankshaft Screws And Special Tool (11 9 601)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Apply a light coating of oil to special tool 11 9 601  .

Position PTFE ring (2) with supporting ring (1) on special tool 11 9 601  .

Push PTFE ring (2) over supporting ring (1) in direction of arrow up to crankcase.

Fig 4: PTFE Ring, Supporting Ring And Installation Direction

Courtesy of BMW OF NORTH AMERICA, INC.

Remove supporting ring from special tool 11 9 601  .

Fig 5: Special Tool (11 9 601)

Courtesy of BMW OF NORTH AMERICA, INC.

Draw in PTFE ring with special tool 11 9 602  in conjunction with special tool 11 9 603  until flush.

Fig 6: Special Tool (11 9 602) And (11 9 603)

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.